Zinc epoxy corrosion protective coating


Polyzinc is a single component zinc rich epoxy coating for the protection of steel reinforcement and metalwork against corrosion.


  • Excellent corrosion prevention properties
  • Quick drying, can be over coated after a short period
  • Excellent adhesion to steel
  • Services as primer for various maintenance systems
  • The zinc content provides an electro chemical protection

This TDS is applicable for the United Arab Emirates only. Please contact your local Polybit sales office for the available TDS in your region

Step by Step

Surface Preparation

All the corroded steel on the repair area should be fully exposed and all loose particles along with rusted scales shall be totally removed. Steel should be cleaned to a bright condition especially at the rear of the exposed bars by wire brushing or grit blasting. Ensure the surface is clean and dry and clear of oil, grease, dust etc.


Mix the contents of the pail with a paddle mixer fitted to a slow speed drill to remove any sediment prior to application.


Application can be done by brush. Ensure that the entire steel is coated properly. A second coat is recommended to be applied so that all pin holes are covered completely. The second coat shall be applied only after first coat dries off completely. The application of repair mortars should start immediately after the coating dries.