Skip to Content

POLYBIT BITUSTICK R 300

Geo-textile fleece surfaced and polymer modified bituminous self adhesive waterproofing and protection membrane

  • High resistance to puncture
  • Good resistance to tear propagation
  • Resistant to UV degradation

Features and benefits

Bituminous self adhesive membrane laminated onto a tough geo-textile fleece. The membrane is specially designed to provide a high level of protection for waterproofing membranes applied on underground concrete structures against mechanical loads and pressure.

Properties

Description

POLYBIT® BITUSTICK R 300 is used as a protection membrane for applied waterproofing membrane or coating in, basements, footings & raft foundations, tunnels & underpasses, manholes and water retaining structures.
Available pack size: 2.7mm

Documents and downloads

How to use

SURFACE PREPARATION & PRIMING

The surface shall be cleaned thoroughly of all contaminants
like dust, traces of curing compound, oil and grease. All
surface imperfections, protrusions, structurally unsound
and friable concrete must be removed and repaired with a
suitable Polycrete* concrete repair mortar.
Apply Polyprime SB* (solvent based primer) @ 4- 6 m²/L to
a clean smooth and dry surface by brush, roller or spray.
Allow the primer to dry prior to the application of the
membrane.

ALIGNMENT

Start the installation of all membrane plies from the low
point or drains, so the flow of water is over or parallel to
the plies, but never against the laps. All overlaps at the
membrane seams shall be installed so as to have “up”
slope laps over “down” slope laps. Begin membrane
application by unrolling the roll of Bitustick R 300
membrane and aligning the side laps. Re-roll the roll
halfway and stand on the unrolled portion to prevent
shifting. 

APPLICATION

Unroll only the required length and cut the piece to the desired shape. Place the membrane piece on the area to be covered and check whether they match with the profile of the marked substrate. Peel off the release film and carefully place the membrane with 50 mm overlap on the selvedges alone. The membrane shall be butt jointed at the ends using Bitutape TS as the underlayment to provide a watertight seal. 

Related articles

  • Bitustick Cool

    The Next Generation of Performed Bituminous Coatings 

  • Foundations and Roofing Systems

    Discover, feel and touch our systems, through our mockup simulation boxes 

  • Wet Areas and Flooring Systems

    Discover, feel and touch our systems, through our mockup simulation boxes 

  • Polycryl FR

    The Ultimate Fire Rated Coating Solution 

  • Polycryl PF

    Strong UV protection For Polyurethane Foam Roof  

  • Bituplus Ultra

    The Ultimate Torch On Membrane Range 

Related products

  • ${/content/heliux/adhesive/polybit/com/en/products/central-pdp#/polybit-polyprime-sb/SAP_0201WEP345J0/searchResult.productFields.MainImageAltText}
    POLYBIT POLYPRIME SB
    A quick drying solvent based low viscosity bitumen primer. It is used as a primer coat on masonry and concrete substrates to improve the adhesion of bitumen based membranes and coatings. 
  • ${/content/heliux/adhesive/polybit/com/en/products/central-pdp#/polybit-bitutape-ts/SAP_0201WCP34GD7/searchResult.productFields.MainImageAltText}
    POLYBIT Bitutape TS
    Bitutape TS is a non-reinforced twin side adhesive bitumen membrane which comprises of polymerized bitumen sandwiched between a plastic release film on either side. 

Frequently asked questions

It is recommended using solvent based bitumen primer conforming to ASTM D 41

No. We recommend liquid applied waterproofing coatings for wet areas

No further protection layer is required