POLYBIT Polypoxy MH
Epoxy resin based lining and benching mortar

Pour the entire contents of part B (hardener) into part A (base) and mix thoroughly for a few minutes with a paddle mixer fitted to a slow speed drill to get a homogenous mix. Then add the part C (powder) slowly into the mixed resins container and further mixed continuously till a uniform consistency is achieved. As the products are supplied in pre-weighed packs, part mixing is not at all recommended, since the cured product will not achieve its full properties even if there is a small variation in the mixing proportions. Apply the mixed mortar immediately after mixing on the tacky primed surface firmly with a steel trowel or spatula. For vertical and overhead surfaces the mortar is to be applied at a maximum thickness of 10mm to avoid sagging. However, for additional build ups, the epoxy mortar can be applied at thicknesses up to 30mm in the second layer. The second layer of application is to be done only after the first coat has achieved its initial cure i.e., after 24 hours of application.