- Cold applied
- Single component, easy to apply
- Can be used in both dry and damp substrates
-
Cold applied
-
Single component, easy to apply
-
Can be used in both dry and damp substrates
-
Can be applied in closed or confined areas
-
Water based
-
Joint free
POLYBIT® POLYCOAT RBE Can be used for a wide variety of applications, which includes the following: – protective coating on concrete foundations – curing compound on freshly cast concrete structures – dampproof membrane in sandwich constructions – vapor proof barrier coating. Available sizes: 20L, 200L
The surface shall be cleaned thoroughly of all contaminants
like dust, traces of curing compound, oil and grease. Light
mechanical high pressure water jet
may be used to clean the surface of all the contaminants
depending on the degree of contamination on the surface
to be coated. All surface imperfections and protrusions
shall be removed and repaired.
It is highly recommended to apply a priming coat prior
to the application of the Polycoat RBE coating on the
substrate. The primer can be applied to damp or
freshly cast concrete surfaces.For highly demanding situations, it
is recommended to apply in multiple coats. On vertical areas, it is recommended
to apply the coating in multiple layers.
Polycoat RBE coating should be protected from getting
damaged. Coating laid on horizontal surfaces can be
protected either by a cement sand screed (50mm thick) or
by an asphaltic protection board (Bituboard)*.
Bituboard can be fixed on the membrane by a double sided
bitumen adhesive tape
Substrate must be sound, free from dust, loose particles, oil, traces of curing coampound and any contamination. May be applied to damp but not waterlogged surfaces.
There is no special primer. Primer can be prepared at site by diluting this product with 20% by volume of clean sweet water.
No. It is a water based green product