POLYBIT POLYTEX GREY
Elastomeric acrylic waterproofing and protective coating

Mix the contents of the drum prior to the application to
remove any sediment. Polytex can be applied by soft
bristled brush, roller or an airless spray. When applying
by airless spray then dilute the coating with approximately
5% water to reduce the viscosity of the coating. Apply
the first coat of undiluted material at a coverage rate of
1L/m²/coat to get a Dry Film thickness of 0.50 mm. It is
important to ensure that each coat has to be cured totally
before applying the next coat. The second coat should be
applied at right angle to the first at the same coverage
rate, to ensure a full unbroken coating to the substrate. For
improved strength and flexibility, embed a 65 g/m2 non
woven geo-textile membrane whilst the first coat is still wet
on all corner joints, fillets and pipe penetration joints. Allow
the coating to cure fully for 72 hours to achieve its full
properties.