Solvent free epoxy resin coating


Polypoxy FC is a versatile, two component solvent free epoxy resin based floor and wall coating that provides a durable and impervious coating which is easy to clean and have excellent resistance to a wide range of chemicals. 


  • Excellent resistance to a wide range of chemicals
  • Hygienic. Provides an impervious and seamless surface which is easy to clean
  • Durable and hardwearing
  • Easy to apply
  • Available in a wide range of colors
  • Solvent free, therefore odorless and can be applied in confined spaces

This TDS is applicable for the United Arab Emirates only. Please contact your local Polybit sales office for the available TDS in your region

Step by Step

Surface preparation

Surface preparation plays a vital role in determining the durability of any floor coating. Therefore proper care should be taken while executing it. The surface should be dry, free of any cement laitance, oil and grease, curing compound and any other contaminants, which may affect the bonding. Light mechanical scabbling, grit/captive blasting or grinding is recommended for cleaning the surface of such contaminants. New concrete surfaces should be 28 days old and the moisture content on the surface must be less than 5%. Refurbishment of existing or old floors must be done with a suitable repair mortar, in order to ensure that the bond between the old substrate and the new flooring system is very good. Surface  irregularities and blow holes shall be repaired with Polypoxy BF* (Epoxy resin based blow hole filler and skimming mortar) or Ceresit RS 88* (cementitious repair mortar). Alternatively an epoxy resin based scratch coat can be used when repairing larger areas (> 0.5m2). The surface should be vacuumed after carrying out the necessary cleaning for removing the dust debris left over after the cleaning process. 


On most new concrete floors priming may not be required. However for best adhesion, prime the prepared surface with Polyprime EP* @ 4-5m2/L. The coating is applied when the primer is dry. However, in all circumstances, the coating shall be applied within 24 hours of application of the primer. If the primer surface is left open for more than 24 hours, then a fresh coat of primer has to be re-applied. 


Mix part A (resin) and part B (hardener) separately for 1 minute using a slow speed drill fitted with a paddle. Then add Part B into Part A and mix thoroughly for 2 – 3 minutes to achieve uniform  consistency. Apply immediately after mixing. 


Polypoxy FC has to be poured and spread evenly on the floor with a squeegee. The coating will then be finished by rolling the surface with a roller. When the first coat achieves initial cure (i.e. after 24hours) apply second coat at right angles to the first. After application the coating must be back rolled to reduce surface irregularities and improve bonding. Care should be taken to ensure that a continuous film is achieved.