- Excellent corrosion prevention properties
- Quick drying, can be over coated after a short period
- Excellent adhesion to stee
-
Excellent corrosion prevention properties
-
Quick drying, can be over coated after a short period
-
Excellent adhesion to stee
-
Services as primer for various maintenance systems
-
The zinc content provides an Electro chemical protection
POLYBIT® POLYZINC is a protective coating to steel reinforcement in concrete repair applications – as a primer for steel surfaces prior to final coating.
Available pack size: 1L
All the corroded steel on the repair area should be fully
exposed and all loose particles along with rusted scales
shall be totally removed. Steel should be cleaned to a
bright condition especially at the rear of the exposed bars
by wire brushing or grit blasting. Ensure the surface is clean
and dry and clear of oil, grease, dust etc.
Mix the contents of the pail with a paddle mixer fitted
to a slow speed drill to remove any sediment prior to
application.
Application can be done by brush. Ensure that the entire
steel is coated properly. A second coat is recommended to
be applied so that all pin holes are covered completely. The
second coat shall be applied only after first coat dries off
completely. The application of repair mortars should start
immediately after the coating dries.
It is a single component zinc epoxy corrosion protective coating
Yes. It can be applied on steel reinforcement bars and steel structures
Yes it is compatible with cementitious and epoxy repair products