- 4 Provides an instant seal and exhibits good resistance to water and vapors
- Good Adhesion to many substrates
- Good Adhesion to many substrates
-
4 Provides an instant seal and exhibits good resistance to water and vapors
-
Good Adhesion to many substrates
-
Good Adhesion to many substrates
-
Easily applied by hand pressure only
-
Available in wide range of widths & Colours
-
Lasting protection in all climates
POLYBIT® Polytape AL is used for flashing, sealing and repair against ingress of water for mobile homes, small commercial roofs, residential porches and dormers, farm buildings, roof and gutter patching and on profile sheets. It can also be used as a flashing on up-stands. Avaialble Size: 10Mx100MMx1.2MM
The surface shall be cleaned thoroughly of all
contaminants like dust, traces of curing
compound, oil and grease. All surface
imperfections, protrusions, structurally unsound
and friable concrete must be removed and
repaired with a suitable POLYCRETE* concrete
repair mortar.
The adhesion can be improved by apply
POLYPRIME SB* @ 4- 6 m2/lt to a clean smooth and dry surface by brush,
roller or spray. Allow the primer to dry prior to the
application of the membrane. Unroll only the required length and cut the pieces
to the desired shapes and size.
Place the pieces of membrane on the area to be covered and check
whether they match with the profile of the marked
substrate. Peel off the release film from the self
adhesive side and start unrolling the membrane
and press it to the surface. Smoothen the
membrane from the center to the edges with a
wooden press in order to remove any entrapped
air.
Yes. Solvent free epoxy based primer to be used
1L per coat can cover approximately 4 sqm at 250 microns dry film thickness
For a
non slip finish, broadcast non slip Aggregate No 3 into the
primer coat or first coat of Polypoxy FC @ 0.3kg/m² and
remove excess prior to application of next coat.