- Cold apploed
- single component easy to apply
- can be applied on damp substrates
-
Cold apploed
-
single component easy to apply
-
can be applied on damp substrates
-
water based
-
joint free
POLYBIT® POLYCOAT RBE 10 Can be used for a wide variety of applications, which includes the following: – protective coating on concrete foundations – curing compound on freshly cast concrete structures – dampproof membrane in sandwich constructions – vapor proof barrier coating for interior & exterior floors & walls. Available sizes: 20L, 200L
The surface shall be cleaned thoroughly of all contaminants
like dust, traces of curing compound, oil and grease. Light
mechanical grinding/grit blasting/high pressure water jet
may be used to clean the surface of all the contaminants
depending on the degree of contamination on the surface
to be coated. All surface imperfections and protrusions
shall be removed and repaired
It is highly recommended to apply a priming coat prior
to the application of the Polycoat RBE 10 coating on the
substrate. The primer can be prepared in the site by diluting
Polycoat RBE 10 with 20% water. Depending on the dry film
thickness required, apply the rubberized bitumen coating
@1–4m²/L./coat. On vertical areas, it is recommended
to apply the coating in multiple layers
Polycoat RBE 10 coating should be protected from getting
damaged due to the ongoing site activities and during
backfilling. Coating laid on horizontal surfaces can be
protected either by a cement sand screed (50mm thick) or
by an asphaltic protection board (Bituboard)*
Substrate must be sound, free from dust, loose particles, oil, traces of curing coampound and any contamination. May be applied to damp but not waterlogged surfaces.
There is no special primer. Primer can be prepared at site by diluting this product with 20% by volume of clean sweet water.
No. It is a water based green product