- High resistance to hydrostatic pressure
- Monolithic waterproofing system
- Chemicals remain active
-
High resistance to hydrostatic pressure
-
Monolithic waterproofing system
-
Chemicals remain active
-
Resistant to chlorides and sulphates and other
mild chemicals -
Non toxic
-
Suitable for use in potable water
POLYBIT® POLYCAP - active chemicals present in PolyCaP penetrates deep into the water bearing capillaries, reacts with water and free lime and subsequently develops insoluble crystals and thus effectively prevents further infiltration of water.
Surface to be treated must be free from dust, oil,
grease, residual curing compound, release oil,
paint etc. Surface should have open capillary
system.
PolyCaP is normally applied by
masonry brushes or by appropriate powder spray
equipment. Apply the material in two coats. The
second coat is to be applied at right angles to the
first coat whilst the first coat is still green but firm
(usually 3-4 hours after the first coat). The slurry
should be used within 20 minutes after mixing
PolyCaP must be prevented from drying out too
rapidly and should be kept damp for 5-7 days.
Mist spraying and covering with Polythene sheet is
effective.
This is a cementitious tile adhesive
For indoor and outdoor applications on walls and floors
C1T as per EN 12004