Skip to Content

POLYBIT CE 47

Epoxy tile grout

  • Easy to apply
  • Suitable for swimming pools & wet areas
  • Chemical resistant

Features and benefits

Epoxy joint filler for chemical resistant grouting.

Properties

Description

POLYBIT® CE 47 is used for permanent, chemical-resistant grouting of ceramic tile coverings, acid-resisting clinker, split tiles and clinker floor tiles. For grouting areas exposed to aggressive substances, e.g. commercial kitchens, battery stores, car washes, swimming pools, laboratories. Available pack size: 5kg kit.

Documents and downloads

How to use

Surface Preparation

CE 47 adheres to all solid, load-bearing, clean and dry surfaces free of substances which can cause separation. The surface, thin-bed mortar or bedding mortar must have set sufficiently hard, and joints must have been uniformly scraped.

Application

CE 47 is supplied in two components. Add hardener (component B) to the base solution (component A) and mix with an electric drill and mixer attachment at approx. 400-800 rpm until completely free of lumps. It is absolutely necessary to lift off the complete tin lid, using e.g. a screwdriver or trowel, and to scrape the hardener (component B) with a spreader or trowel completely out of the upper into the lower container (component A = resin) where the 2 components are mixed until a homogeneous mixture is obtained. When using only partial amounts, it is necessary to remove them by scraping from the two containers. Ensure a uniform, homogeneous colour of the mixture. Cleaning Emulsify any access CE 47 on the tile surface by making circular movements with a coarse sponge pad and very little water. Wipe off the resulting slurry with a soft sponge (hydro sponge). Then wipe again using a clean, soft sponge and very little water. Frequently rinse the sponge in clean water. Do not begin cleaning the surface before CE 47 has started to set. For final cleaning wait at least 3 but no more than 6 hours to remove the remaining film from the tile surface with a soft sponge. 

Finishing

Use CE 47 only at surface and air temperatures of 10°C to 40°C. CE 47 contains epoxide com pounds. CE 47 in white may discolour (yellow) if exposed to heavy UV Light. Should you need support or advice, please consult our technical service. 

Related articles

  • Bitustick Cool

    The Next Generation of Performed Bituminous Coatings 

  • Foundations and Roofing Systems

    Discover, feel and touch our systems, through our mockup simulation boxes 

  • Wet Areas and Flooring Systems

    Discover, feel and touch our systems, through our mockup simulation boxes 

  • Polycryl FR

    The Ultimate Fire Rated Coating Solution 

  • Polycryl PF

    Strong UV protection For Polyurethane Foam Roof  

  • Bituplus Ultra

    The Ultimate Torch On Membrane Range 

Related products

Frequently asked questions

Yes. It is a chemical resistant grout

Yes. It is suitable

Yes. This is anti-fungal & anti-microbial