POLYPOXY EC

Description

Epoxy based cementituous repair system for concrete floors

 

Polypoxy EC is an easy to use, three component epoxy based cementituous repair system used for concrete repair applications prior to application of floor coating systems. It is designed for filling cracks, minor imperfections on concrete surfaces and doing patch repairs.

Properties

  • Easy to use
  • Can be applied from 3 mm to 10 mm
  • Good adhesion with the concrete & no primer required
  • Environment friendly
  • Economical
  • Can be troweled to a smooth finish
  • Can be applied on vertical surface

Documents and Downloads

Technical Data Sheet
POLYPOXY EC
Download TDS

This TDS is applicable for the United Arab Emirates only. Please contact your local Polybit sales office for the available TDS in your region

Step by Step

Surface preparation

The concrete surface should be thoroughly cleaned of all loosely adhering particles, laitance, dust, oil, grease, paint, etc. Grit / captive blasting and mechanical grinding is recommended for removing all surface contaminants.

Mixing

Pour the entire contents of Part B (Hardener) into Part A (Base) and mix thoroughly for a minute with a heavy duty paddle mixer fitted to a high torque slow speed (300-400 rpm) drill to get a homogenous mix. Then add Part C (Powder) slowly into the mixture and further mix continuously until a uniform consistency is achieved. As the products are supplied in pre-weighed packs, part mixing is not recommended, as the cured product will not achieve its full properties even if there is a small variation in the mixing proportions.

Application

Application can be carried out by a steel trowel or putty knife or scrapper. Press firmly the mixed mortar into the area to be filled to ensure proper adhesion. The area repaired with Polypoxy EC can be over coated with any epoxy or polyurethane coating after it achieves its initial cure.